disabling S3300 notification record

Download as PDF

In this post I will show you how to disable a notification record which appears always after you type a configuration command. This notification causes your frustration when you want to configure anything on this switch and suddenly you see the following record:

[labnario]interface GigabitEthernet 0/0/1
[labnario-GigabitEthernet0/0/1]
Jan  1 2008 00:24:47+01:00 labnario DS/4/DATASYNC_CFGCHANGE:OID 1.3.6.1.4.1.2011.5.25.191.3.1 configurations have been changed. The current change number is 24, the change loop count is 0, and the maximum number of records is 4095.

You have such situation on S2300, S3300 and S5300 switches if you are logged by the console.

How to cope with it?

You have two ways to do this. The first is to disable it temporarily by the following commands:

undo terminal monitor

or

undo terminal trapping

The only disadvantage of the temporary solution is that after you are logged by the console once again this notification still exists. At the same time you block all notifications in the console view.

The second solution is to disable this notification in info-center of the switch:

[labnario]info-center source DS channel console trap state off level warnings

How to find appropriate parameters for this command?

You can find all needed information from this notification:

Jan  1 2008 00:24:47+01:00 labnario DS/4/DATASYNC_CFGCHANGE:OID 1.3.6.1.4.1.2011.5.25.191.3.1 configurations have been changed. The current change number is 24, the change loop count is 0, and the maximum number of records is 4095.

Source: DS
Level: 4 (warnings)
Channel: console.

Advertisements

3 thoughts on “disabling S3300 notification record

  1. mschedrin

    >[labnario]info-center source DS channel console trap state off level warnings
    Will this command disable only DATASYNC_CFGCHANGE notfications or anything more?

    Reply
  2. labnario Post author

    It will disable only DATASYNC_CFGCHANGE notification. Theoretically it should disable all OIDs in DS module but as I checked there is only one OID in DS module: 1.3.6.1.4.1.2011.5.25.191.3.1. I will try to confirm it tomorrow.
    Thanks for this question.

    Reply
  3. TeMP

    Turn off all inf. to console:
    “info-center source default channel console log state off trap state off debug state off”

    Reply

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s